No. Edge Comfort is an air-side PCM comfort kit plus a DIY retrofit workflow. The goal is to increase comfort hours by storing coolth and buffering room heat, not to act like a compressor-based cooling system in every climate.

We sell and ship the ultra-high-conductivity, shape-stabilised PCM modules. Studio AI Hub is the online calculation model used on this website, not a physical product. Sensors, furniture, fans, adapters, shading and recharge equipment are customer-supplied or bought independently from third-party sellers.

Yes. A bench, sideboard, cabinet or simple flat-pack build can work if air can pass through the PCM bank. Studio provides cut-out templates, airflow layouts and a parts list so the furniture stays yours.

The Studio marks missing DIY parts as partner picks. You can buy the suggested category from a partner or swap in any equivalent fan, adapter, shade or recharge device that meets the airflow and capacity guidance.

Performance depends on night temperatures, humidity, solar gain, room type and whether night ventilation is possible. Studio first classifies passive charging fit as Strong, Moderate or Limited before suggesting the kit.

If night air is too warm, the Studio model calculates a suggested off-peak recharge window for your existing AC or portable cooler. You operate it with your own timer or control equipment. If you do not have suitable equipment, Studio can suggest a third-party category.

The roadmap uses sealed, shape-stabilised PCM modules designed to avoid leakage. Commercial release still requires material compliance, electrical integration checks and product safety testing before broad deployment.

That is one of the main design goals. The retrofit is low-intrusion and reversible: use furniture you own, avoid facade impact, and follow local rental rules for window adapters or small cut-outs.

It is intended to be IKEA-level DIY: a template, a parts list, simple cut-outs, a fan, PCM modules and Studio guidance. More complex rooms can still use installers or B2B partners.

Yes. Qualified local partners can integrate PCM modules into repeatable room or ceiling applications, while Studio uses the building, local weather, heat load and recharge path to support project-specific sizing.

Yes. The module platform spans six phase-change temperatures from 22°C to 32°C. Higher-temperature modules can be charged during off-peak hours with a small fan heater or an air-source heat pump for gentle, even warmth. Either way, the PCM holds the room in a steady comfort band instead of letting temperatures swing.

Edge Comfort supplies the agreed PCM product and technical scope. A qualified local channel or delivery partner leads the customer relationship, site information, integration, installation, local compliance and service.

The qualified local partner or another suitably qualified contractor identified in the written project scope. Electrical work, building work and local approvals remain with the parties legally responsible for them.

The standard monitoring route measures room temperature and relative humidity, then derives agreed comfort-hour, threshold and recharge metrics. It does not require cameras, audio recording or device tracking. Data access, retention and any occupant feedback are agreed in the written project scope.

The partner and Edge Comfort review the agreed measurements, installation experience, limitations and commercial lessons. The result may support a repeatable local offer, a redesign, a further test or a decision not to scale.

They remain independently sold by their authorised sellers. The seller handles checkout, collection, fulfilment, returns and warranty. Edge Comfort may identify a compatible category but does not become the seller or warranty provider for that equipment.

Coverage for Edge Comfort PCM products is documented in the written quotation or supply agreement. Third-party equipment remains covered only by its authorised seller or manufacturer under their own terms.